![]() Included in the file download are baseline settings for quite a few materials. First, I would suggest to start small and use a piece of material as a test project. The intricate design was no problem for the xTool to cut and we are. Paula found a lovely 3D butterfly from GemXXDesigns on Etsy which is ideal as a piece of wall art. The settings we used were 7mm/sec speed and 100% power. Hi I'm Erik!You can purchase the xTool D1 laser engraver and cutting machine directly from xTool where they often have great deals. If a new version of Laserbox basic is found, update it to the latest version. Double-click the Laserbox basic icon to open it. Use the USB cable to connect xTool D1 to your computer. Planner parameters.Turn on the power switch of xTool D1. The same material from different suppliers will vary, So the following parameters are for user's reference only and need to fine-tune the parameter on themselves. The cut was pretty smooth, and the edges had fewer burnt marks.Light-colored woods such as birch, cherry, or maple can be vaporized well by the laser and are therefore more suitable for engraving. The laser module cut basswood, pinewood, walnut wood, and Fraxinus Mandshurica wood in only one pass. …Basswood We set the speed of xTool D1 at 1 mm/s and power at 100%. ![]() medic458 Noob Reactions: Posts: 9 Joined: Sun 12:33 am.Position Material in xTool D1. The positioning accuracy is …Project settings, materials, hardware, tips & tricks, etc. The processing area is 432 x 406mm, which is slightly larger than A3 size, and the engraving speed is 0-160mm/s.Choose Menu > Check for Updates.Xtool d1 material settings Perform the following steps to update the firmware of xTool D1: 1.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |